Small Glider Power Pod

This Small Glider Power Pod can be used on a range of mini gliders around 175 - 300g weight. Specifically developed for the AngelWing Designs Genteel Lady 1200mm span kit.

This 3D printed electric power pod uses a pusher configuration. The pusher system allows for a small folding propeller to be used without the risk of it snagging on the motor pylon. Curvature on the base plate designed to fit against the leading edge of an AG25 wing section.

For convenience the designers suggest the speed control is left in the fuselage of the aircraft, doubling as a BEC to power the RX and servos in pure glider mode without the pod fitted. A pair of 3pin JTXH connectors (like used on a lipo balance plug) proved ideal for conncting the motor. Look out for the how to videos on Nick Chitty Flying over on Youtube. The motor leads can be routed internally and pass through a small hole at the front of the pylon. The motor mount itself allows for some adjustment of the thrust line. We suggest that you just spot glue the mount initially and make adjustments if required. The amount of up thrust needed will vary from model to model and the CG can also have an impact upon this.

Weight of power pod: 10.2g

Please note that the motor and propeller are NOT included. Colour may vary. The plastic can deform if it gets too hot. Keep out of direct sunlight for extended periods.

Recommended accessories

iFlight XING2 1404 3800KV - 4600KV or Sunnysky R1106 5500 RPM/V motors.
(The iFlight motor is known to fit the push on propeller, some motor shafts are slightly undersize on other brands that we have tested. Secure with a little CA if the prop slips)

Hobbywing Flyfun 6A or HyperFlight 28A speed controller

Bonka LiPo 2S 300mAh

4x2 folding propellor assembly