Review by: David HVery effective and sticky but has its limits
Bought this to decorate and personalise my Weasel Trek slope soarer and it did a great job. Itís very sticky and it had no problem sticking to the smooth shiny foam surface of the Weasel.
It doesnít have much stretch to it though, so if your model has anything more than the slightest compound curve youíll need to cut darts into the film to get it to follow the surface. Unfortunately, the colour of the film appears to be applied to its upper, non-sticky surface, and where the darts end Iíve found the colour will quickly wear / flake off. Itís no big deal though, and is obviously only visible up close.
Given you obviously canít use heat-shrink film on a foamie (or you wonít have a flyable foamie afterwards!), this does a good job. Bear in mind you donít get a lot in each pack (check those measurements), so make sure you order enough for your needs.
Review by: David ThorpeDisagree with last post
Yes it's expensive and of course it's not pre-cut so you create your own shapes but you do have time to reposition it as the grab, unlike other trims I have used, isn't instantaneous. Try repositioning carefully cut out So....trim. the film delaminates leaving very difficult to remove patches of colour behind.
I much prefer this product
Review by: AnonymousWaste of money
Not precut. On the net it looks like the trim sheets are precut.
Better buy it much cheaper somewhere else.