Review by: David H
Very effective and sticky but has its limitsBought this to decorate and personalise my Weasel Trek slope soarer and it did a great job. It’s very sticky and it had no problem sticking to the smooth shiny foam surface of the Weasel.
It doesn’t have much stretch to it though, so if your model has anything more than the slightest compound curve you’ll need to cut darts into the film to get it to follow the surface. Unfortunately, the colour of the film appears to be applied to its upper, non-sticky surface, and where the darts end I’ve found the colour will quickly wear / flake off. It’s no big deal though, and is obviously only visible up close.
Given you obviously can’t use heat-shrink film on a foamie (or you won’t have a flyable foamie afterwards!), this does a good job. Bear in mind you don’t get a lot in each pack (check those measurements), so make sure you order enough for your needs.
Review by: David Thorpe
Disagree with last postYes it's expensive and of course it's not pre-cut so you create your own shapes but you do have time to reposition it as the grab, unlike other trims I have used, isn't instantaneous. Try repositioning carefully cut out So....trim. the film delaminates leaving very difficult to remove patches of colour behind.
I much prefer this product
Review by: Anonymous
Waste of moneyNot precut. On the net it looks like the trim sheets are precut.
Better buy it much cheaper somewhere else.