The
Epower Plus 90A ESC is a good quality electronic speed control with a switch mode BEC (battery eliminator circuit) for powering the RC. The BEC supplies 5.5V at a current of 5 A continuously. Adequate cooling is required for sustained running at the maximum continuous full power ESC and BEC current limits.
The Epower Plus has powerful braking facilities to ensure that folding props fold correctly, without over straining the gearbox. Note as supplied the brake is not enabled and the programming card will be required to enable it.
The ESC uses a fast 32bit processor, allowing high commutation speeds as often seen on geared motors. The speed control incorporates large smoothing capacitors to ensure smooth running of the motor.
| Epower Plus ESC Specifications |
|---|
| Continuous current |
90 A |
| Max current (10s) |
100 A |
| Voltage range |
6V - 22V (2S-6S LiPo) |
| BEC type |
Switching (uBEC) |
| BEC output voltage |
5.5V |
| BEC continuous current |
5 A |
| Dimension |
65 mm x 32 mm x 14 mm |
| Weight bare/inc cables |
40 g / 64 g |
| Switching rate |
8 to 32 kHz |
| Programmed using |
E-Power Plus Program Card |
| Motor wires |
5 cm with 3.5mm sockets |
| Battery wires |
10 cm with XT60 connector |
| RC wire length |
15 cm |
447821351341
sales@hyperflight.co.uk
Contact Form
