Apex F5L 2m RES Electric Glider

First shipment sold out. More arriving Mid April. Please order now to reserve one.

The APEX F5L is the latest 2m RES electric glider development by Stefan Schweiger, designer of the internationally proven Purito. Following four years of continuous development and testing, the APEX represents a systematic refinement of the Purito concept with emphasis on aerodynamic efficiency, energy retention, and performance in wind.

The aerodynamic layout and airfoil system were designed by Eser Kismir.

Structure & Construction
The wing utilises a tubular main spar layout with construction principles derived directly from the Purito platform, for ease and accuracy of assembly. Structural design prioritises torsional stiffness, load consistency under launch, and repeatable build accuracy.
The kit follows the established Purito construction methodology and is optimised for precise, low-tolerance assembly.

Ballast System
Internal ballasting is implemented through the wing spar, positioned directly at the model’s centre of gravity (CG).
Typical flying weight: 380–480 g
Additional ballast capacity: up to 90 g, installed via the canopy - to be confirmed
This configuration allows rapid mass adaptation without CG shift.

Flight Characteristics & Measured Performance
The APEX has been validated through competitive flying and direct comparative testing against lightweight Purito setups.

Glide & penetration
In zero-air comparative tests from equal launch height:
- Flight time: no measurable difference
- Distance covered: 30–40% greater for the APEX
This confirms higher average airspeed at equivalent sink rate.

Wind performance
The airframe allows operation at a significantly higher base speed while maintaining controllability, providing improved penetration and working range in moderate to strong wind.

Geometry & Specifications
Wingspan: 2000 mm
Wing chord: 190 mm
Tip chord: 104 mm (5 different airfoil sections used across the span)
Wing area: 34 dm²
Wing configuration: 3-piece design
Airfoil: Proprietary in-house design by Eser Kismir
Fuselage length: 1280 mm
Ready-to-fly weight (F5L version): approx. 420 - 480 g

In the future there will be two fuselages available, one intended for cased outrunners like the Dualsky XM2527EG-23 and another designed for drone type outrunners like the T-Motor F60 Pro. However currently (March 2026) only the Dualsky version is available.

For more info and a very nice build log see this RCGroups thread.

Recommended RC
Rudder & elevator servos	KST X06, CHA DS06
Spoiler servos (2) (frames for KST X06H included)	KST X06H, CHA DS06
Receiver	5 channel receiver to match your transmitter

Motor Recommendation
Motor	Dualsky XM2527EG-23
Spinner	30mm Dualsky Spinner for 3.17mm shafts, 30mm GM F5J Spinner, 3.2mm Split Collet for GM Spinners, 30mm Ali Spinner
3S Prop blades	Vitaprop 8x4, Vitaprop 8x5, Dualsky 8x5.5
ESC	Dualsky SUMMIT 30 SLIM 6V SBEC ESC, Dualsky SUMMIT 30 SLIM 8V SBEC ESC
3S Battery	Bonka LiPo 3S 300mAh, Bonka HV LiPo 3S 520mAh, Radient LiPo 3S 450mAh, 3S 300 - 850mAh LiPo