M2 Stainless Steel Pushrod Ends for 1.5mm Rods (2)
Description
A pair of high quality stainless steel pushrod ends with M2 threads cut at one end and a tube to take a 1.5mm or smaller carbon or metal pushrod. Note two SS pushrod ends only are supplied, rods and clevises must be purchased separately. Suitable for 1.4 mm to 1.5 mm carbon or steel rods. Attach by coating the pushrod in epoxy or thick CA. The hole is to allow the air and excess glue to escape. Degrease before gluing.
| Stainless Steel 1.5mm Long Pushrod End Specification | |
|---|---|
| Pushrod hole size | 1.5 mm |
| Pushrod tube length | 10 mm |
| Threaded portion length | 11.5 mm |
| Overall length | 26 mm |
| Thread size | M2 |
| Weight (each) | 0.70 g |
Reviews 10
RichardO
United Kingdom
M2 pushrod ends
I use these in conjunction with MPJ clevises to all the pushrod to be adjusted. They are a bit pricey, but they are nicely machined to match different pushrod diameters. As always, Hyperflite's service was super and arrived next-day.
RICHARD EDMUNDS
United Kingdom
CCM Toy
Useful connector for carbon rod. Used a small drill bit just to clean the inside.
RICHARD EDMUNDS
United Kingdom
CCM Toy
Useful connector for carbon rod. Used a small drill bit just to clean the inside.
RICHARD EDMUNDS
United Kingdom
CCM Toy
Useful connector for carbon rod. Used a small drill bit just to clean the inside.
favonius
United Kingdom
ok
carbon needed a little sanding to fit. zapped in place.
Kev
United Kingdom
M2 stainless steel pushrod ends
1.5ml pushrod ends perfect fit for 1.5ml carbon pushrods little bit of epoxy and solid.
Fabby service quick postage
