|Powerline Micro 1025 Specifications|
|Motor name & type||Powerline Micro 1025/F5J geared inrunner|
|Motor diameter||22.0 mm||0.87 in|
|Motor length||48.0 mm||1.89 in|
|Gearbox diameter||22.0 mm||0.87 in|
|Gearbox length||22.0 mm||0.87 in|
|Motor+GB length||70.0 mm||2.76 in|
|Motor+GB weight||103 g||3.64 oz|
|Lead length||6.0 cm||2.36 in|
|Shaft diameter||5.0 mm||0.20 in|
|Mounting info||4 M2.5 holes on a 17 mm diameter|
|Estimated GB efficiency||95 %|
|Estimated Rm||31 mR|
|Estimated Kv||4900 RPM/V|
|Estimated geared Kv||726 RPM/V|
|Estimated Io||1.2 A @ 10 V|
|Max efficiency (10 V)||85 % @ 20 A|
|Operating efficiency (10 V)||75 % @ 40 A|
|Recommended battery||3S LiPo|
|Rec max LiPo capacity||1.3 Ah (any bigger and the motor could overheat)|
|Recommended prop||15x8; 15x10 16x8|
|Input power||450 W on 16x8 prop|
|Current||45 A on 16x8 prop|
|Supplied accessories||4 mounting screws, 4 washers, 3 3.5mm plugs & sockets|
Review by: Don Richmond
Excellent motor for Volo and MaxA. Small, light and powerful. Models balance well with 850 mah battery.
Outstanding service and very fast delivery.
Review by: Brian
Got this for Nan shadow as I needed something small and light. Don't require competition performance so proped down to 15 x 8 GM with spinner, (very neat job) to keep amps and heat down. Only using 850mah lipo to get CG without adding tail weight but manage 3-4 climes of 20 seconds and even when no lift about comes down barely warm. Good choice for narrow fuselage.
Review by: Eamon KeatingExcellent F5J Motor
I purchased this for my Xplorer F5J and have to say it has exceeded all expectations. It is thin and light and provides a powerful pull to take the model to 200m in around 20 sec. Neil was very helpful, as always. Thank you
Review by: AndersLight and powerfull
Very nice fit in my new Avenger f5j. Small motor, gives nice room for battery. Light weight together with 850mAh 3s battery. Enough power👍🏽
Review by: Mikael
Fantastic motor for the Maxa 4 m... Outstanding service
and fast delivery from Hyperflight all the way to Sweden.
Review by: FoxbatImpressive
I am very impressed with this motor. It's a high quality geared inrunner. The included hardware (mounting screws/washers) were well received. It will be going into a new Supra Pro Competition E with forward mounted elevator & rudder servos. The delivery time to Australia was very prompt (less than a week). Thank you for a great service.
Review by: Deo van der spuyPowerline Micro
I am very impressed with this little motor, very light and very powerfull. Modified my Xplorer F3J for this motor setup, even with servos still up front only 6 grams of ballast was needed in the tail. RFM 16x8.5 prop a little hard to find though, currently running a 14x9.5
Review by: Anonymous
Brilliant little motor. Perfect for my eSupra where the low weight of this motor helps keep overall flying weight down. Neil delivered promptly.
Review by: Wren
What a superb device.
Super light weight, tiny, and perfectly powerful enough for a 4.0m F5J ship.
One is singularly impressed!
Review by: Sebastian
A lot of Power for my Avalon! works great with a RFM 16x8 propeller and Vladmirs Hyperspinner. Used mine with a YGE 60 ESC and Turnigy Nano Tech 1300Mah 90C battery wich gives me around 4 takeoffs in the air.
Light and priceworthy!
Review by: Wren
What an extraordinary little motor!
Following a run without prop, I installed the motor in my Hyper Ava and fitted a 15x6 prop; with a 1300mAh 3S LiPo. I operate the motor from a switch, so there is no gentle ramp up to max rpm as when using the normal throttle stick.
Switch on and OMG! Stuff blown everywhere. Astounding, scary even. I have now fitted a 13x8. The reduced thrust will be welcome for the maiden flight, which should happen in a couple of days.
You might guess that I do not require a high rate of climb for my calm conditions F5J.......
This motor is tiny, light, and amazingly capable!