Replacement spread carbon wing for a Blaster 3 DLG SC. Includes the throwing peg and control horns. Contact us to determing the availability. We are sometimes willing to break apart a full kit.
Replacement wing for a Blaster 3 DLG. Includes the throwing peg. Contact us to determine colour and availability. We are sometimes willing to break apart a full kit.
Molded Kevlar nosecone for a Blaster 3 DLG (Nosecone only, not nosecone, pod and boom as shown in some of the photos)
Blaster 3 DLG glider fuselage set. This includes the pod, the nosecone, the boom, and the tail V mount.
A replacement Vladimir's Models throwing peg, as supplied with the Blaster 3 DLG. This throwing peg is beautifully molded from carbon fibre, and finished with a smooth surface to maximise launch height and comfort. Symmetrical, so it can be used for right handed and left handed throwers. One supplied per order. Glue the horizontal mounts over the tip of the wing with epoxy or good quality thick CA. To eliminate the chance of it coming loose drill a 3 mm hole all through the mount and wing and ...
This is the pastic part that is used to fix the composite "lollypop stick" holding the ballast to the Blaster 3 DLG fuselage.
Ballast slug for adding weight to the Blaster 3. Cleverly designed to allow the centre of gravity postion to be tuned as required. Adding this ballast piece allows the Blaster 3 to be flown in up to 14 mph winds with ease. Weight = 60 g
Large ballast slug for adding weight to the Blaster 3. Cleverly designed to allow the centre of gravity postion to be tuned as required. Adding this ballast piece allows the Blaster 3 to be flown in up to 17 mph winds with ease. Weight = 85 g
Replacement rudderless fin, suitable for a Blaster 2 or a Blaster 3 DLG. Don't be taken in by the photo, there is NO rudder on this fin.
Replacement fin for Blaster-3 DLGs Also suitable for a Blaster 2 DLG - it is the same size as a Blaster 2 fin, but with a smaller rudder to reduce blowback on launch.
Replacement tailplane for the Blaster 3. This is smaller (34cm span) than the Blaster 2 tailplane (38cm span). Weight = 7g
A very high quality DLG throwing blade, with the popular bird wing shape. Beautifully molded from carbon fibre, and contoured to maximise launch height and comfort. Symmetrical, so it can be used for right handed and left handed throwers. The weight can be decreased by reducing the thickness of the carbon towards the ends of the blades, and by profiling the edges, to approximate to a thin ellipse. To fit, open the end of the model's wing, and glue the tang inside the wing with epoxy or good...
This carbon tailplane V mount fits all versions of the Blaster 2 and Blaster 3. Supplied with a custom machined alloy sleeve nut to retain the tailplane. Also ideal for own designed models. Based on the Mark Drela design, this superb quality mount is hand crafted from high modulus carbon and keeps the tailplane above the turbulent flow near the fuselage. This increases the amount of laminar flow on the tailplane, reducing drag. Although it looks spindly it is in fact very strong, and none have ...
Replacement aileron/flaperon horns for all Blaster 2 and Blaster 3 models. Supplied in pairs (2).
Replacement rudder horn for all Blaster 2 and Blaster 3 models. Supplied singly.
Two wire soldered into a tube pushrod fittings to take 0.8 mm carbon rods. As used on the Blaster 2, rh Blaster 3, and other models.
